Results 1 to 3 of 3

Thread: Speedo Problem

  1. #1

    Speedo Problem

    Anyone know how they work these days.
    Mine has decided to have a rest. #???
    In the good old days there was a plastic arm thingy that stuck down into the water off the transom and used to pivot up with water pressure and give an approximate reading.

    Now I think the speedo runs from the motor somehow, is a 4st 60 hp Merc, 2003 model, and the speedo was surprisingly accurate , when compared to the GPS. #

  2. #2
    Aaron_Fogarty
    Guest

    Re: Speedo Problem

    Mate
    There is a tiny pitot hole on the front edge of the skeg on the outboard. They often fowl up. Above this there is a small plastic tube (12" above) usually painted, so you probably haven t noticed it. Disconnect it at this point and blow some comressed air down the short length towards the pitot pick up. This usually will clear the line.
    Aaron

  3. #3

    Re: Speedo Problem

    Thanks Aaron, that will be it for sure, I neglect to mention in the original post that I slid it over a submerged log in Hussey Creek, (Pumistone passage) just before I noticed it wasn't working.
    Motor was out of gear and I was only going about walking speed, didn't think I did any damage , but probably picked up a bit of rotten wood in the hole.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Join us