My new Cheese Cutting Board

[magicpudding]

I'm not sure how others have rigged their deckwash, but ours consists of a scoop mounted at the bottom of the trandsome, port side, , sealed entry through the hull ABOVE THE WATER LINE, which then leads to a shurflow high pressure pump on the inside of the trandsome. It works a treat, and an awesome addition was one of those coily hoses you see at boat shows.

CJ

[Bowser]

Have a look at the Seaquip site for some ideas. I had them put my centre console, collapsable T-Bar, engine well and bait board in. The work was first quality and the boat is so much better with it. Good height to work at, no more sore back from bending to work or guts all over the boat. There bait board does not have the front bar so is easier for filiiting as you can get flat against the board it need be without stuffing your knife. I put a couple of blobs of silicone on the front edges to stop the splosh and allow the water to drain out of the hole and down the tubes. Works fine.

http://www.seaquip.com.au/