Eliminator prop nut

[chris69]

[QUOTE=Dignity;1704922]

And that's the issue both Rayken and myself are alluding to. Once the shear pin snaps how do you undoe the eliminator as normally you'd hold the prop to stop the shaft turning. Maybe if the motor isn't fully stowed it might be in gear but I doubt it.

Jack, no rocks up my end so can't comment.

Yes i can see you point but ive never broken one but others have i suppose i can pre drill a small whole to put a screw drive through it that would be the most clever thing to do it just go posted today so ill wait until i get it and ponder the sitiation were theres a will theres a way.

[Dignity]

[QUOTE=chris69;1704943]

Yes i can see you point but ive never broken one but others have i suppose i can pre drill a small whole to put a screw drive through it that would be the most clever thing to do it just go posted today so ill wait until i get it and ponder the sitiation were theres a will theres a way.

Yep, it's called an angle grinder 😆