New tinnie recommendations

[Sparky89]

Hi guys
Looking to buy a new tinnie, looking for something thats bass/bream style suited thats got a decent front and rear casting deck that can hold a 90-115hp motor, always can pull a skier or tube if needed. What are some decent boats out there at the moment? Cheers

[gunna]

Clark Dominator

[Noelm]

Must be a thousand boats that will fit your intended use, probably best to do a bit of googling, then a few trips to various dealers.

[RayLamp]

One thing that came to mind was this https://www.barcrusher.com.au/models/535xs/

[Sparky89]

Seen the dominators and barcrushers, there not bad but they dont have rear casting decks and i dont want the anchor well up front, only few boats i've found are the trophy hornet, tabs wildfisher and a few of the bluefin models that suit what i want

[Kero]

Aluvan Razor S or Katana. Built locally in Brisbane.

http://www.aluvan.com.au/images/Page4.compressed.pdf

http://www.aluvan.com.au/images/Page7.compressed.pdf

[bluefin59]

Seen the dominators and barcrushers, there not bad but they dont have rear casting decks and i dont want the anchor well up front, only few boats i've found are the trophy hornet, tabs wildfisher and a few of the bluefin models that suit what i want

Bluefin boats are Gold Coast built and can be customised to a certain degree, Iv had a great run from mine and would recommend one , the Aluvans look good as well . Matt

[Sparky89]

Bluefin boats are Gold Coast built and can be customised to a certain degree, Iv had a great run from mine and would recommend one , the Aluvans look good as well . Matt

What model bluefin you got? I've been looking at the firecat

[bluefin59]

I have had my 4.5 mt predator for 13 yrs mate , it has a 60 hp mariner with over 900 hrs on it now and has traveled an unbelievable amount of kms now . The only problem I have had is with the floor needing to be replaced but I till love my boat and would be hard pressed to change . Matt

The wildcat is a good looking boat as well I personally don't like my casting deck up under the gunnels as I like to be sure I am going to stay in the boat when chasing mackerel and Tuna , Matt

[scottar]

Hi guys
Looking to buy a new tinnie, looking for something thats bass/bream style suited thats got a decent front and rear casting deck that can hold a 90-115hp motor, always can pull a skier or tube if needed. What are some decent boats out there at the moment? Cheers

Bit out of left field and not tin but quieter with a better ride and just as tough if not tougher. Casting platforms aren't hard to fab up.

http://www.polycraft.com.au/model-ra...by/frontrunner

[Noelm]

I personally don't quite see a huge benefit in having a casting deck with zero freeboard, but it seems to be the rage.