Hey guys just a quick one. my 30 hp yamaha tiller steer has become quite hard to steer when motoring. when the boat is at rest its not an issue ,but when going even slow she is dam hard to steer.? any ideas?
Thanks
Hey guys just a quick one. my 30 hp yamaha tiller steer has become quite hard to steer when motoring. when the boat is at rest its not an issue ,but when going even slow she is dam hard to steer.? any ideas?
Thanks
Have a look under the cav plate and look for the little fin/anode if it has just started being hard to steer it may have come loose and fallen off...........If it has always been hard to steer you may just need to give it a little "tweek'.
Confidence.......the feeling you get before you fully understand the situation.
You could start by greasing it via the nipple and then look at the nut that tightens steering on shaft, it may need loosening..
I've pupmed grease in it. its not tight or hard to steer when at rest or out of the water,only when motoring. thanks dan ill have a look tomorrow .
Are you driving it with the leg trimmed in?
Darren
Check the rubber engine mounts....should be three of them.....if one lets go it sits crooked and hard to steer.
Jack.
How much grease did you pump in - does the motor have an upper and lower nipple on the steering tube? Mates motor did this - pumped half a grease gun into it to fix it. As mentioned also check the mounts.
Posting Permissions
Reply With Quote