idle screw for 2001 yamaha 130hp 2 stroke

[PixieAU]

Hi all

Motor is due for a service in about 15hrs but was hoping to make do with a small tweak until then.

Motor is occasionally stalling at idle (in gear), real PITA when lining up the trailer to idle on to it.

Thought a minor tweak on the idle screw might see me over until next service. Really only needs an extra 50 - 100 rpm I reckon.

Can anyone point me to the idle screw. Perhaps a photo or screenshot from workshop manual. I'm sure I could locate it eventually but hoping to avoid the 'trial and error' approach.

Thanks in advance.

[whiteman]

Small stainless screws with tension springs around the threads located at the top of each carberator next to the brass coloured plug.

[Gazza]

M8 , if idle specs are "suss" why not just use your "fast idle" lever temporarily.

[Spaniard_King]

Small stainless screws with tension springs around the threads located at the top of each carberator next to the brass coloured plug.

130 only has 1 idle screw so ???????????????????

STBD side of carbies the screw in question needs a small flat blade screw driver to be inserted from the top of the carbies and screwed down to increase RPM it is stainless steel and will have a spring between the screw head and the carby body

[PixieAU]

thanks Spaniard, do you do services northern suburbs of Brisbane as well as trailer service?

Gazza, its when it idles in gear and the throttle lever doesn't work in gear.

[Spaniard_King]

Jim McKinnon is your man "Aqua Mobile Marine" as good as ya get

[PixieAU]

Jim McKinnon is your man "Aqua Mobile Marine" as good as ya get

thanks man. will look him up when the time ticks over