HDS Fuel Flow calibration - Reset and Reconfigure

[honda900]

This video footage is how to reset your fuel calibration when it gets out of whack, basically you need to remove and re-add the device, in my case a suzuki engine. this will remove and readd the device, setting the configuration back to the default.

Make sure your engine is turned on or you wont be able to see it in the device list.

Also if you are configuring an engine interface for the first time, this will also assist, if you watch the video you will see I go through the process of adding / reconfiguring my engine. You will need to need to do the fuel tank configuraion first (mine is already done in this video.).

Regards
HOnda.

Click on the picture below to play...

[Moonlighter]

Nice Video Chris.

In my attempts to get my "fuel used" data to read correctly I cant tell you how many times I ran thru that procedure. Hopefully the new interface cable will sort it out - will know when I do my next trip!

Grant

[honda900]

Grant,

good luck, I found the new update to be worst yet.

Regards
Honda.