I am just about to slop some flowcoat on the interior of my boat and would like to use the splatter/speckle finish. Many just use a brush and flick the coloured bits on but I was looking for a more even finish. If I recall it is using a low pressure with a spray gun. If anyone can gove me the details it would be greatly appreciated
Cheers
Neil
A Proud Member of
"The Rebel Alliance"
G'day
Neil, as exactly as you have described. Both the methods I have seen are to flick it with a brush, or thin it as required to run through a gun on low pressure. Just remember to mix your mekp as per atmospheric temps and be aware of the time you have to use it.
Dave
Oh goodo then.
Would you mind around to the Loganholme place and pickup the little Beaver and do the inside of it too Neil??
I would be very appreciative.
I intend on living for-ever....so far so good
Any idea of pressure or tip size to get the flowcoat getting the right finish
A Proud Member of
"The Rebel Alliance"
Posting Permissions
Reply With Quote