How to sync watersnake remote?

[davez104]

Hi all,

I have a new watersnake bowmount that comes with the remote controls. Apparently you need to sync the remote to the motor to be able to use it, but the instructions are non-existant. I know it has something to do with the little white button under the top cover, but could not get it to work. Hoping someone here knows the process. Failing that, I'll shoot an email off to Jarvis Walker.

Cheers,
Dave.

[davez104]

Nevermind. I sent an email to Jarvis Walker just after I posted here, so for future reference, here is the procedure:

WATERSNAKE

Procedure to sync the remote control to the motor


Please try the following procedure:

1) Remove motor head cover.

2) Press and hold down the RC chip button.

3) Press any button on the remote control hand unit

4) Release the RC chip button after the indicator light flashes.

5) If the indicator light fails to flash repeat steps 2-4.

6) Replace the motor head cover.




If the above procedure is not successful, please refer to the following:

1) Make sure the battery in the remote is not flat it should be 2 to 3 volts.

2) Press the RC button and the on/off button on the remote at the same time (red light should come on)

3) Hold them down until motor starts running (app 10 sec)

4) Release the RC button