bt50 bullbar rod holder

[seameter]

Hi. ive got a bt50 which is fitted with the genuine mazda alloy bullbar. Because of its shape i cannot mount the normal wilson rod holder or anything similar to it onto the car as the rods would be on far to much of an inwards angle so i need something that can mount onto the bar and then swivel around so the rods are on less of an angle. Does anyone know if such a thing exists straight off the shelf? or will i need to get something made up

[tenzing]

what about a 2 piece wilson holder.
The female part stays attached to the bar tube and the actual rod tubes are on a stem that slides into the female part. They dont swivel but are adjustable for height above the bar.
Is that of any use?
Brendan

[jameshallam]

theres a national recall on all bt-50 at the moment faulty bonnet stricker apparentally there 1 in 10 is cracked all tested and replaced under warenty if needed

[YOOT]

Hi. ive got a bt50 which is fitted with the genuine mazda alloy bullbar. Because of its shape i cannot mount the normal wilson rod holder or anything similar to it onto the car as the rods would be on far to much of an inwards angle so i need something that can mount onto the bar and then swivel around so the rods are on less of an angle. Does anyone know if such a thing exists straight off the shelf? or will i need to get something made up

Buy the two piece Wilson rod holder and bend/twist the stem around until its straight. Otherwise get a 3" adaptor kit and put it in the centre. I had to do this for my Navara. As long as the rods are slightly to the left it is legal.