Daiwa Baitcasters-cast Control

[wjgrnp]

I would appreciate any feedback on the difference between Magforce V and Z on Daiwa Baitcasters.
From other info on here I have understood the difference between Z and PE however have been unable to locate any threads on V v- Z.
Thanks

[Strewth]

All you need to know can be found at

http://www.tackletour.net/T3Forum/vi...force++++brake

Personally, I prefer the V over the Z as on my Bass and Barra rods it seems to handle handle lighter lures better (< 10g). For heavier lures, there is little difference between the two, even though the Z is touted as being better for long distance casting. The type of spool bearing used has a much greater influence on casting distance and performance than whether the spool has V or Z braking. Ceramic ABEC 5s with a drop of low viscosity lube (eg Yellow Rocket Fuel, Oust or Team Daiwa) are the go.

[wjgrnp]

Strewth
Thanks for the feedback.
The article has filled in all the gaps.
Who do you suggest as the best source for bearings.
I appreciate your help.
wjg

[Strewth]

I get mine from Smoothdrag.com in the US. Very fast service, minimal postage cost and they will set up an on-line payment facility for your order. Boca bearings also offer a huge range.

Make sure that order them DRY, otherwise they come packed with grease and you will need to flush them out.

You will need to make a spool pin removal tool. We copied the ones shown at

http://heartlandtackleservice.com/spoolpliers.stm

They work a treat.

[alphas]

This too is a good read.
http://www.japantackle.com/Topics/brake_system.htm

[wjgrnp]

Mick
I appreciate your help
regards
wjg