Page 2 of 2 FirstFirst 12
Results 16 to 26 of 26

Thread: Solo boat retrieves in high current

  1. #16

    Re: Solo boat retrieves in high current

    I am surprised how many people do not have a nose or tail rope secured to their boat.

    both can make thigs much easier by yourself.

    If you only have a small boat, driving on simply isnt practical...... even if my trailer was designed for drive on I would have to back the car half way into the water to get the trailer far enough in...... then without motorised tilt and trim the whole thing becomes completly impossible.

    cheers
    Its the details, those little details, that make the difference.

  2. #17

    Re: Solo boat retrieves in high current

    Well 2-3 metre tides aren't big compared with what we deal with around Mackay. I usually fish by myself at Sarina and probably have to admit to having a couple of problems from time to time when retrieving the boat (4.35 Seajay).

    I do not drive on as I have decided not to dunk the trailer bearings. Most of the trailer is above the water level.

    When I pullout the cable I only give enough to hook up the boat so the boat rests on the lower roller. Wind it up a little, straighten the boat if necessary,then continue winding.

    We have a lot of cross current at Sarina inlet, combined with the tide and the wind normally adds up to an interesting retrieval, but so far I haven't had too many issues as long as not too much cable is used. That's where you can have a problem.

    Steve

  3. #18

    Re: Solo boat retrieves in high current

    a rope tied to the front would hold it in place i would think and then tied off while you hook up the cable to the boat

  4. #19

    Re: Solo boat retrieves in high current

    if you make up a combined rope and very strong rubber bungee connection which you have to stretch to connect the bow eye to the winch post that will hold the bow on the rollers while you connect the winch. Its like having an extra person.

  5. #20

    Re: Solo boat retrieves in high current

    Quote Originally Posted by Scott nthQld View Post
    Idunno Chris, with a 2 speed winch, I can get my boat up in a matter of seconds, using the 1:1 cog. Plus I think by yourself winching is safer as you don't leave the boat unsecured, what would happen if it rolled off the trailer while you were trying to hook the winch up? In my area, with the influx of stingers this time of year as well as other biteys that are around, I'll stick to my winch thanks.

    Scott ...... I dont leave my boat
    As I drive up & make contact with the post roller ........ I leave the motor going - walk up the front lean over & hook on the winch cable (tighten it)* & put on the safety chain ......... go back to the helm & turn the motor off ....... Hop over the front onto the draw bar ...... often I dont even get my feet wet
    Last week at Hawkes nest ...... I really saw the struggle that people were having in a strong cross current & wind ........ I felt for them

    Chris
    Give a man a fish & he will eat for a day !
    Teach him how to fish
    & he will sit in a boat - & drink beer all day!
    TEAM MOJIKO

  6. #21

    Re: Solo boat retrieves in high current

    drive on is by far the easiest, quickest & safest way for me both with the sea ray & the ski boat. put your trailer far enough in the water (don't worry about wet berrings yes they don't last as long but they only cost $20 every 2 years or so) so as your boat can float & touch the skids. drive boat on till it is held by the skids then when straight power up till you touch your front holding block. (if need be leave in gear whily you lean over the bow & attach safty chain & winch. turn off & raise motor. climb out over the bow onto the draw bar then to car. no bities & only wet toes. if you find a quiet boat ramp & ebbing tides & practice it won't take long to learn then you can launch & retrieve any boat in any coniditions by yourself quickly & safely..
    ps take the time to practise & learn & you will enjoy your trips much more as it is 1 worry that you will never experance again.
    alse self centering spring rollers are a good help too but not nessarry.
    cheers
    rick

  7. #22

    Re: Solo boat retrieves in high current

    Regardess of what method you use, that is the point you have to have a method or a system.

    There are so many out there who even tough they have put there boat in and out plenty... still have not thaught about it and develeoped a system that allows for the problems.

    I always let the boat out with the winch cable connected and the bow rope in my hand.

    when the boat is in the water I disconnect and hook the winch rope to the rear roller.

    The winch rope is then always right where i need it when I pull out.

    This alone solves soo many problems.

    Soo many boat trailers are poorly set up and the boat will not slide on or off smoothy........ so drive on is out of the question.

    If a bloke has to fight to get his boat off, how much trouble is he in when he wants to get it back on.

    A have to agree that a pair of wobble rollers at the back are a great thing.....I have both wobble rollers and the original centre roller.

    cheers
    Its the details, those little details, that make the difference.

  8. #23

    Re: Solo boat retrieves in high current

    Can u organize someone with a lot of experience to go with u to show u some tips especialy driving on for the first time if your trailer is no setup right ie; not enought rollers to cradle the boat u may put stress crack in the alloy.Some of them trailer setups from the factory are pretty basic,its a bit different when your tinny has a 4mm/5mm bottom and u have forward/centre controls with power trim the weight is evened out a little better.Hate to see you beach ya boat up on the trailer guard the first time or chew up ya prop . keep practising u will get a routine going that works.Even drive down to a buzzy ramp and just watch to see other peoples methods aways someone with clever ideas.

  9. #24

    Re: Solo boat retrieves in high current

    Quote Originally Posted by NAGG View Post
    Andrew ...... if you have a trailer that allows you to drive the boat on ...... then learn to do so !

    Basically you drive against the current at 45 Deg ....... Get the nose onto the trailer ( which should be around the centre) .......... As the tail swings with the tide & straightens the boat ......... you accelerate forward & onto the bow roller.

    this procedure is simple with a little practice. ( i handle my boat on my own in all sorts of conditions)


    I hate to say it ..... but winching is for mugs (specially in flowing currents or strong winds) & if only people took time to set there trailer up properly & learnt to drive their boat on ........ things would be a lot more pleasant at the boat ramps


    Chris
    Chris, dont underestimate your skill as a lot of average boaties struggle with this. I spend many hours at the boat ramp as an assessor for skippers tickets and see one boat per week on average damaged by driving on (mostly missing the center rollers) scoring the hull as the trailer coming from the dealer is poorly set up. Also in my area the ramp is only concrete for a certain distance and the council fills behind the conctrete with gravel and rocks. Driving on pushes all of this futher out and creates a drop off. Another thing depending on your area, have a close look at all of the loose sand etc thats going into your motor while your driving on in the one spot stirring it up. Having said that it is a pleasure to watch someone who can do it well and quick. My preffered option is to have self centering rollers at the back and self centering skids for at least the first center roller. Use the bow rope to pull in on the rollers, tie the bow rope tight to the winch post, connect the winch rope and the boat will self centre pretty much on any angle as you winch it up.

  10. #25

    Re: Solo boat retrieves in high current

    Andrew,
    im guessing its the burrum ramp ur having difficulty at.As has been said just angle the trailer either upstream or downstream depending on the tides.ou cannot drive the boat on at the burrum ramp in a northerly wind at high tide. I saw two boats holed last xmas doing it. the swell lifts the boat up at the wrong moment and plunges down,in both cases the roller came away from the pin/bracket and on the bottom of the next swell drove the boat down on the exposed post. Drive on by all means at the harbour but give it a swerve at hight tide at burrrum. ill give you a ring later in the week if ur up for a fish this weekend,though the weather looks iffy again.
    chewy....

  11. #26

    Re: Solo boat retrieves in high current

    Quote Originally Posted by chewy01 View Post
    Andrew,
    im guessing its the burrum ramp ur having difficulty at.
    chewy....
    yeah burrums been the main issue. I also noticed the swell, and didnt try the drive on. I did manager a drive on at wals camp yesterday, after reading this thread and getting a bit of confidence.

    I found my main issue has just been dunking the trailer too deep. I had it 3/4 of the way up the wheels, and it was just enough to lift it off the centre roller. When its halfway up, the rollers do thier job better, as long as Im patient.

    I wont try to drive on at BH in swell tho, thanks.

    Yeah Sat sounds good if the weather is ok. I might even try Thurs nite.
    See my post on fishntales? Thanks for the hint chewy.....

    cheers to all who posted tips
    ANdrew

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •