E-tec Fuel gauge hole size

[Steven78]

Good afternoon.
I just won a Northstar F210 fuel gauge which requires a 52mm hole I am hopeing I can just remove the old OMC-E-tec gauge and replace it. Is there any tricks to it. I feel a bit funny cuting more holes in the dash.

Many Thanks Steve



</IMG>

[Spaniard_King]

Steve,

The etec gauge should be a 54mm hole.. the f210 will fit in no problem.. just center the gauge by eye and tighten the single securing nut at the rear of the gauge. you wont see any difference in the gauge face size.. ie same as the etec gauge

[Steven78]

Thanks Garry thats the good news i was looking for
Should I wire the gauge to the Ignition so its on only when the motor is on?

[Spaniard_King]

yeh .. it needs to come on and off with the ignition

[Steven78]

Thanks Garry Its sound like a very easy unit to install Thanks.
I cannot wait to see the fuel results.