Blown Trim n Tilt

[dnej]

Brumby,
Give Paul a call at Yatala Yamaha,and ask him if that is the case.He was into Johno some time back.Great guy to talk with.Tell him I sent you.
( The guy with the new plate bottom)
David

[Brumby]

Thanks David, I'm open to all the advice I can get, don't mind spending the money on a new one if I have to, but it's a lot of beer and fuel down the drain if i can get away for less.

Cheers

Carl

[Brumby]

Carl,

I have an official OMC Service Manual that covers your motor. You are welcome to have it, no use to me now.

Cheers

Dave

Dave, many thanks the manual arrived safely - just wasn't able to communicate before as Ausfish had fallen over and i hadn't even saved your tel number elsewhere! I've had a look through the relevant section and although I'm happy enough to do the removal, I'm a bit nervous about stripping and repairing the thing, so I'll leave that part to my mechanic.

There is lots of other good stuff in there though and I can see the manual coming in handy down the line.

Cheers

Carl

[Outsider1]

Hi Carl,

thanks for letting me know. Happy that it will be useful to someone else. Yeah, hydraulic seals can be a bit tricky.

Good luck, the weather is too good for us to be sitting at home today. I might get out for a run later. Planning a fishing trip Thursday, but of course the forecasts now suggest a southerly change is on its way

Cheers

Dave