PHP Warning: Use of undefined constant VBA_SCRIPT - assumed 'VBA_SCRIPT' (this will throw an Error in a future version of PHP) in ..../includes/functions_navigation.php(802) : eval()'d code on line 1 Rod Dryer Designs Please
Hey, wondering if anyone could help me with a design for a 15 Rod- Rod Dryer. I have 4 singles units going at the moment but i want to try and run One moter unit to Power 15 chucks. Or smaller Doesnt Matter But needs to hold 10 or above
Yeah a drum dryer is good but hard to build cause i build up to 15"9 rod they have a 21" Sand spike and the pole in the middle will sag over that distance
How about one with drum sections that can be added or removed or making it telescopic as the rod length dictates??
Just use a single bearing post on the pointy end as well as the two bearing support at the motor end and that way everything wouldn't be supported from the drive end as they normally do. And if your doing short rods just take sections off the pointy end and that'll make it a normal drum dryer.
You'd have to make sure the dryer is longer then the long rods though otherwise
Make the shaft 25 or 30mm ali tube and take it down to about 20 or so mm to go into the bearing/s at each end and that shouldn't bend in the middle.
How many of these long suckers would you do compared to say 9'er's or shorter??
That shouldn't be too hard says the bloke on the keyboard.
hey guys thanks for the ideas much appreciated. Came up with an idea while fishing this morning using an A frame system and one drive motor. I will post pics of it when it is complete so when ppl want ideas they can have it.
Rod Dryer Designs Please
Originally Posted by finga
Posting Permissions
Reply With Quote
