its a deep cycle batt in the jump pack
Cheers Murf
Will my deep cycle battery be enough to start my outboard if my marine battery goes flat?
Its pretty new, about 110 amp I think. Do they have the cranking power, or are they different from standard marine batteries?
I had trouble using the DC in such a fashion last week, after the main battery wore out trying to start the Tohatsu 40 in damp conditions. Lucky I also keep a jump pack which did the trick.
The DC is really for the minn kota, but Im just curious if they 'should' work as a backup. Maybe my connections werent tight enough.
cheers
Andrew
its a deep cycle batt in the jump pack
Cheers Murf
I have 2 deep cycle 75ah batteries and start the motor no probs (115hp). All the advice I had was that deep cycle will be no probs as a starting motor.
hi Gecko
Maybe you need to get some of these stowaways?
http://www.exideworld.com/products/m...away_dual.html
Cheers
Chimo
What could go wrong.......................
Andrew,
depends on what type of deep cycle battery.
some are run only (used in allot of 4X4s for the fridge) and some are deep cycle crank.
obviously the crank deep cycle will do it with easy. ( same as in the jumper packs)
but the other will struggle to wind it over at all.
neil
neil is right, there are 2 different types of deep cycle. I have a 120a/h and a 75a/h AGM deep cycle batteries, and both will start the 'lux if need be. There is a type of deep cycle that is specifically designed for slow disharge ONLY. They are a LOT heavier & a LOT more expensive. But they hold their charge a hell of a lot londer and are worth it if that is what you want.
If your deep cycle was the latter type you would know it. So it is most likely that yopur battery is more than equal to the task starting of starting the outboard.
Brett
May 2006 Order New Hilux - June 2006 Order ARB & Other Goodies - August 2006 Organise fitting of ARB & Other Goodies - 2nd September 2006 Delivery of New Hilux with Goodies - 2nd September 2006 Break Goodies - 3rd September 2006 Use Angle Grinder to Modify New Goodies - 4th July 2007 BEND ARB rear protection bar (Big Rocks) - 31st July 2007 Notice cracked welds in the ute tub. TWIST!! - September 2007 Bend Alloy Side Steps - Feb 2008 Install steel side steps - March 2008 Bend Steel steps & Punture Diff Lock Air Line