rwells9999
17-09-2002, 07:18 AM
Hi all,
I have had an lot of you out there contact me re the seat that I had made for my Stacer Centre console. I had it made by Seaquip in Brisbane at a cost of $320 plus upholstery. The seat is 700 high, 750 wide and 350 deep. It is partitioned of with a 400mm storage area under the padded seat top, and that allows a 300mmm underneath, it's finished off in white powder coating. The swing back is constructed of S/Steel. I had this exact seat in my last centre console, and I know how precious space is. I'm amazed how many rigs I see with the 'Standard' fitout, you loose so much valuable space. The esky type of seat is fine but where do you put all those bits you need to get access to. I have the plans so if any of you want them, drop me a line.
Robin
I have had an lot of you out there contact me re the seat that I had made for my Stacer Centre console. I had it made by Seaquip in Brisbane at a cost of $320 plus upholstery. The seat is 700 high, 750 wide and 350 deep. It is partitioned of with a 400mm storage area under the padded seat top, and that allows a 300mmm underneath, it's finished off in white powder coating. The swing back is constructed of S/Steel. I had this exact seat in my last centre console, and I know how precious space is. I'm amazed how many rigs I see with the 'Standard' fitout, you loose so much valuable space. The esky type of seat is fine but where do you put all those bits you need to get access to. I have the plans so if any of you want them, drop me a line.
Robin