PeterInSA
04-02-2016, 03:34 PM
Have upgraded to a 4 stroke and down graded the HP on our 1/2 Cabin.
Would like to sell my Blue Band 85Hp motor with Power Trim/Tilt going to the motor
The old 85 install have the tubes from the pump going under and thru the rear well coming out of the top of the well thru a fitting around 100mmx 80mm then to the motor hydraulics.
Can the plastic Hydraulic fitting in the rear well, be cut thru so the cables/tubes are just one length from the motor hydraulics to the pump ie fed to the motor thru the side of the rear well to the pump.
Alternatively purchase new hydraulic tubes from the motor to the pump.
The motor looks new has not done a lot of hours and has been rewired, so would like to give it a new home.
Would not like the new owner to have a 50mm round hold in the middle of the rear well that I have when he upgrades
Thanks
Peter
Would like to sell my Blue Band 85Hp motor with Power Trim/Tilt going to the motor
The old 85 install have the tubes from the pump going under and thru the rear well coming out of the top of the well thru a fitting around 100mmx 80mm then to the motor hydraulics.
Can the plastic Hydraulic fitting in the rear well, be cut thru so the cables/tubes are just one length from the motor hydraulics to the pump ie fed to the motor thru the side of the rear well to the pump.
Alternatively purchase new hydraulic tubes from the motor to the pump.
The motor looks new has not done a lot of hours and has been rewired, so would like to give it a new home.
Would not like the new owner to have a 50mm round hold in the middle of the rear well that I have when he upgrades
Thanks
Peter