baitboard meterial

[MEGA'bite]

Any know where i can get a nice big piece of this meterial in brisbane

thanks in advance

[dnej]

Place at slacks creek.Industrial estate near Compton Road. Will see if I can find my docket.
David

[Angla]

I would also like to know where as my baitboard lid fell off in 11 metres of water yesterday. I am not diving for it so I need a newby.

Cheers
Chris

[MEGA'bite]

bump bump bump

[Ausfish]

For bait boards and cutting boards you are best off with a sheet of High Density Polyethylene (HDPE)

Try http://www.allstarplastics.com.au or http://www.industrialplastics.com.au/

Maybe have a look at using Corian

http://www.casf.com.au/

[Lucky_Phill]

I believe I have found a supplier.

http://www.dotmar.com.au/component/virtuemart/?page=shop.product_details&flypage=flypage.tpl&product_id=112&category_id=169&parentid=112&upid=168&itemid=54


Queensland

Build 1 Unit 3/29 Lysaght St Acacia Ridge QLD 4110

Phone:+61 (07) 3423 8997Fax:+61 (07) 3423 8994

Email:dotqld @dotmar.com.au (http://www.dotmar.com.au/contact/71?itemid=125&to=dotqld)

There may be others, but I need this product as well, so will contact them asap.


Cheers LP.
.
.
.
.
.
.
.

[MEGA'bite]

thanks guys

[oldboot]

Reverse garbage at west end have decent lumps of HDPE from time to time.....havn't seen any recently.

Modular plastics at springwood are decent folk and will cut to size.

Corian is probaly a bit hard on the knives and a bit dear.

cheers

[bar raider]

i have a few that i use for baitboards, it cuts up after a while but just give a bit of a sand and like new again.

i have a few if ya want a peice. on the goldy.