Baitrunner BTR3500 "clicking"

[fender22]

Hi, I have a baitrunner and it's started this annoying clicking noise when retreiving. Doing it whether it's under load or not. It sounds all the world like my Penns when the bail arm hits the handle every few turns but it's not hitting the handle and can't seem to pinpoint it. I took the spool off and nothing amiss in there. Has anyone had this experience with the Baitrunners?

[diabolical]

新建、改建、泳池设备 (http://www.sangya.com/youyongc/ESPA.htm)扩建的游泳池设备必须有池水净化及消毒设备。 3、游泳池设备池壁及池底应光洁不渗水，spa成套设备 (http://www.sangya.com/spa/spa01.htm)呈浅色。池外走道不滑且易于冲刷桑拿设备 (http://www.sangya.com/sangnaf/sangnf.htm)，走道外缘应有排水沟，污水排入下水道。 4、室内游泳池设备采光系数不低于1/4，水面照底不低于80lx。 5、游泳池设备分别设更衣室、淋浴室、spa成套设备 (http://www.sangya.com/spa/spa01.htm)厕所等，淋浴室每项30--40人设一个莲蓬头，女厕所每40人设一个便池，男厕所每60人设一个大便池和二个小便池。其污水排入下水 道桑拿设备 (http://www.sangya.com/sangnaf/sangnf.htm)

Yeah..........What he said..................................wot the.

[Lucky_Phill]

It could be your anti-reverse lever thingie, that has a spring attached to it. It will be sitting inside the body of the reel and on the mainshaft at the base of the spool housing.

Sometimes the spring becomes elongated and will not allow the little cog thing to disengage properly.

I will find the name for you

Phill

[Lucky_Phill]

http://www.shimanofish.com.au/media/fishing/techdocs/en/btr3500b_v1_m56577569830498551.pdf

the number is RD 5455 and it is the anti reverse cam spring.

the RD 5449 is the anti reverse cam.

Hope this helps

Phill

[Heath]

I reckon I know what it is. It happened on my oldmans reel & I have seen it happen only on A & B type reels with the smaller spindle.

What is probably happening is that the bail arm trip mechanism on the rotor is just hitting the trip notch on the reel body. If you file a smidge off the trip notch the noise will go away.

[wags on the water]

It could be your anti-reverse lever thingie, that has a spring attached to it. It will be sitting inside the body of the reel and on the mainshaft at the base of the spool housing.

Sometimes the spring becomes elongated and will not allow the little cog thing to disengage properly.

I will find the name for you

Phill

Great terminology Phil;D ;D

[sid_fishes]

but isn,t that phills problem, the LITTLE COG THING, sorry mate

[Seahorse]

its the lever that sets the bait runner.
when u wind in and the lever clicks back, it doesnt click back completely. just put bit pressure on lever and push it completely back.
my 3500 does same thing. the clicking noise is annoying

greg