View Full Version : Shimano TSS4
Giffo7
23-03-2008, 09:57 AM
I was spinning off Burleigh Heads yesterday with a TSS4 and landed one spotty .about 10 casts later I heard a plop,looked down and it was the drag nut off the front of the reel in the water ! bloke at tackle shop said he had sold about 6 of these for TSS4 reel so far.has this happened to anyone else ?
Cheers
Giffo
trueblue
23-03-2008, 10:19 AM
yep, it happens. got to check the drag every couple of casts. Must be something with the final run of those reels before they discontinued them.
FNQCairns
23-03-2008, 10:24 AM
Yeah that part of them is crap! have yet to lose one though, mine is a bit if a battle to get back on, from new too.
cheers fnq
Giffo7
23-03-2008, 01:48 PM
Thanks
I may have to carry a spare so it wont ruin the day again !
Cheers
Giffo
skipalong
23-03-2008, 03:43 PM
yeah mate it was the type of washer they used there was no give in it and it caused it to loosen even when winding at high speed,
Spectre
24-03-2008, 08:02 PM
Giffo
Yes .....it is a common problem.
Try a couple of turns of threadseal tape on the shaft thread & also some reel grease on the rubber seal under the drag knob.
Should help.
Cheers
Phil
artesian
26-03-2008, 12:48 AM
I'll have to look at my TSS4- never had that problem.
Not really sure why the drag knob would fall off if a fish took a run or if winding in at high speed - but accept that it happens.
If the top drag washer, which should be a metal washer, is keyed to the shaft, and not to the spool, then the drag knob shouldn't come lose if a fish takes a run, or if the drag slips under an enthusiastic retrieve.
Horse
26-03-2008, 07:23 AM
I have two TSS4's. An early 90's model and one about two years old. When I put the old spool on the new reel it unwound and layed the line poorly and I had to shim it to get it working. When the correct spool is used there is no issue.
I have also heard of it happening with some of the recently manufactured reels.
reggy
26-03-2008, 05:17 PM
I bought one about 18 months back and wondered why the drag knob would only wind on about 2 turns. I pulled the drag washers out and got the schematic out and found that I had one too many metal washers in the stack. Took one out and no more problem.:)
the_real_rumbo
27-03-2008, 08:22 PM
yeah my old boy has lost one
Powered by vBulletin® Version 4.2.6 by vBS Copyright © 2024 vBulletin Solutions Inc. All rights reserved.