Rod Dryer Designs Please

[AdamMcD]

Hey, wondering if anyone could help me with a design for a 15 Rod- Rod Dryer. I have 4 singles units going at the moment but i want to try and run One moter unit to Power 15 chucks. Or smaller Doesnt Matter But needs to hold 10 or above

Adam

[finga]

How about a drum dyer??

[AdamMcD]

Yeah a drum dryer is good but hard to build cause i build up to 15"9 rod they have a 21" Sand spike and the pole in the middle will sag over that distance

[finga]

How about one with drum sections that can be added or removed or making it telescopic as the rod length dictates??
Just use a single bearing post on the pointy end as well as the two bearing support at the motor end and that way everything wouldn't be supported from the drive end as they normally do. And if your doing short rods just take sections off the pointy end and that'll make it a normal drum dryer.
You'd have to make sure the dryer is longer then the long rods though otherwise :-X

Make the shaft 25 or 30mm ali tube and take it down to about 20 or so mm to go into the bearing/s at each end and that shouldn't bend in the middle.

How many of these long suckers would you do compared to say 9'er's or shorter??
That shouldn't be too hard says the bloke on the keyboard. :)

Mmm might be a project for next week ::)

[walldog]

How about a drum dyer??


OK gotta show my ignorance here, what the? never seen one got any pics?

Thanks
Walldog

[finga]

Ask and ye shall receive :)
This is from another site and shows the basics

[AdamMcD]

hey guys thanks for the ideas much appreciated. Came up with an idea while fishing this morning using an A frame system and one drive motor. I will post pics of it when it is complete so when ppl want ideas they can have it.