Rod wrapper chucks?

[stevos]

Looking into the options for chucks for the rod wrapper that is under construction.

Short of the self aligning chuck from the rod works I was thinking of something a bit more within the budget.

Noticed the soft rod butt method in previous posts - where can I check out these soft caps and what sizes are they available in?

Anyone got any other smart ideas?

[Heath]

for my wrapper chuck, I made my own.

Used a rubber chair leg cap. Screwed that to the motor & use a hose clamp to hold the rod in. Works a treat & cost a couple a bucks

[DR]

found these on ebay. they are really simple & would be easy to make your own..
http://cgi.ebay.com/ROD-BUILDING-DRYER-DRYING-ROD-CHUCK_W0QQitemZ180087114619QQihZ008QQcategoryZ6214 8QQrdZ1QQcmdZViewItem

[Bearclaw]

The chucks DR has found are so easy to make yourself, I build them with 4 screws. But at that price you are about the same price with the postage as buying all the stuff here. I would go with the ebay guy find out what the postage is shouldn't be more than 5 USD.

[stevos]

Gold DR!

On my way to bunnings now to get a PVC cap now.

Appreciate all the help guys.

Cheers,

Steve

[stevos]

So here is my version of the above. Only took 1 beer and $2.20 at bunnings.

1799

1800

[DR]

woohoo, lookin good:thumbsup:
just don't overtighten it & crush your blank..:o:grin: